ENERGY BOOSTING A/C TUNE UP ONLY $87
Annual Safety Inspection & Tune-Up
If you have an air-conditioner, your A/C may be due for an annual Safety Inspection and Energy-Boosting Tune-Up. A/C manufacturers recommend annual system maintenance.
Evenings and Weekends – Never an Extra Charge!
Product Pages (Main)
SCHEDULE YOUR SERVICEAIR CONDITIONER MAINTENANCE BY ASI
We are here to help. Our certified White Glove Technicians are San Diego’s Best, that’s why all of our air-conditioner services are backed by our 100% Iron-Clad White Glove Guarantee.
Money Back Guarantee
If you are not 100% sure that the cost of the tune-up was offset by increasing the energy efficiency of your system, we will give your money back. No Questions Asked!
Lower Monthly Bills
After having maintenance performed on your A/C, you can guarantee that your equipment will run less and more efficiently – making your electric bill go down!
Fewer Costly Repairs
Properly maintaining your A/C throughout the year can help prevent unforeseen damages and save you loads of money down the road on costly repairs.
6 Month Guarantee!
If your Furnace or Air Conditioner breaks down within six months after your Precision Tune-up and Safety Check, we will credit your entire investment towards the repair or replacement of your unit.
26 Point Energy Boosting A/C Tune-Up
- Blower Motor – measure amperage and voltage for proper operation
- Thermostat – test for proper operation, calibrate, and level
- Cleaning existing air filter (as needed)
- Bearing – inspect for wear and lubricate
- Inspect indoor coil if accessible
- Confirm proper return air and size
- Inspect Condenser Coil
- Refrigerate – monitor operating pressures
- Safety Devices – inspect for proper operation
- Electrical Disconnect Box – inspect for proper rating and safe installation
- Electrical Wiring – inspect and tighten connections
- Test/inspect contractors for burned, pitted contacts
- Inspect electrical for exposed wiring
- Inspect and test capacitors
- Inspect fan blade
- Clean condenser coil and remove debris
- Inspect service valves for proper operation
- Measure Supply/Return temperature differential
- Inspect ductwork for energy loss
- Compressor – monitor, measure amperage and volt draw and wiring connections
- Check Unit for Time Delay Relay
- Check Unit for Isolation Pads
- Inspect suction line for proper fittings
- Inspect all fittings for signs of oil and/or leakage
- Check lines and fittings with refrigerant leak detector
- Check the condition of Blower Belt, if applicable